Reference Guide
Example
OS10(conf-if-eth1/1/7)# mtu 3000
Supported Releases 10.2.0E or later
port-group
Congures a group of front-panel unied ports or a double-density QSFP28 (QSFP28-DD) port.
Syntax
port-group node/slot/port-group
Parameters
• node/slot — Enter 1/1 for node/slot when you congure a port group.
• port-group — Enter the port-group number (1–14). The available port-group range depends on the switch.
Default Not congured
Command mode CONFIGURATION
Usage information Enter PORT-GROUP mode to:
• Congure unied ports in Fibre Channel or Ethernet mode and break out interfaces with a specied speed.
• Break out a QSFP28-DD port into multiple interfaces with a specied speed.
To view the ports that belong to a port group, enter the show port-group command.
Example
OS10(config)# port-group 1/1/8
OS10(conf-pg-1/1/8)#
Supported releases 10.3.1E or later
scale-prole vlan
Congures the L2 VLAN scale prole on a switch.
Syntax
scale-profile vlan
Parameters None
Defaults Not congured
Command Mode CONFIGURATION
Usage Information Use the VLAN scale prole when you scale the number of VLANs so that less memory is consumed. Enable the
scale prole before you congure VLANs on the switch. The scale prole globally applies L2 mode on all VLANs you
create and disables L3 transmission. The no version of the command disables L2 VLAN scaling. To enable L3
routing trac on a VLAN, use the mode L3 command.
Example
OS10(config)# scale-profile vlan
Supported Releases 10.4.0E(X2) or later
show discovered-expanders
NOTE
: This command will be supported in future releases.
Interfaces 107