Reference Guide

Congure advertise TLVs
OS10(conf-if-eth1/1/3)# lldp tlv-select basic-tlv system-name
OS10(conf-if-eth1/1/1)# lldp tlv-select dot3tlv macphy-config max-framesize
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv link-aggregation
Network policy advertisement
LLDP-MED is enabled on all interfaces by default. Congure OS10 to advertise LLDP-MED TLVs out of congured interfaces. Dene LLDP-
MED network policies before applying the policies to an interface. Attach only one network policy per interface.
• Dene an LLDP-MED network-policy on an interface in CONFIGURATION mode.
lldp-med network-policy {add | remove} number
– add — Attach the network policy to an interface.
– remove — Remove the network policy from an interface.
– number — Enter a network policy index number (1 to 32).
Congure advertise LLDP-MED network policies
OS10(conf-if-eth1/1/5)# lldp-med network-policy add 1
Fast start repeat count
Fast start repeat count enables a network connectivity device to advertise itself at a faster rate for a limited amount of time. The fast start
timer starts when a network connectivity device receives the rst LLDP frame from a newly detected endpoint.
When an LLDP-MED endpoint is newly detected or connected to the network, the lldp-med fast-start-repeat-count
command enables the network to quickly detect the endpoint. The LLDP-MED fast start repeat count species the number of LLDP
packets that are sent during the LLDP-MED fast start period. By default, the device sends three packets per interval. Change the number
of packets a device sends per second — up to 10.
Rapid availability is crucial for applications such as emergency call service location (E911).
176
Layer 2