Reference Guide
spanning-tree port
Sets the port type as the EdgePort.
Syntax
spanning-tree port type edge
Parameters None
Default Not congured
Command Mode INTERFACE
Usage Information When you congure an EdgePort on a device running STP, the port immediately transitions to Forwarding state.
Only congured ports connected to end hosts act as EdgePorts.
Example
OS10(config)# spanning-tree port type edge
Supported Releases 10.2.0E or later
spanning-tree rstp force-version
Congures a forced version of spanning tree to transmit BPDUs.
Syntax
spanning-tree rstp force-version stp
Parameters stp — Force the version for the BPDUs transmitted by RSTP.
Default Not congured
Command Mode CONFIGURATION
Usage Information Forces a bridge that supports RSTP or MST to operate in a STP-compatible manner to avoid frame misordering
and duplication in known LAN protocols that are sensitive.
Example
OS10(config)# spanning-tree rstp force-version stp
Supported Releases 10.2.0E or later
spanning-tree rstp forward-time
Congures a time interval for the interface to wait in the Blocking state or the Learning state before moving to the Forwarding state.
Syntax
spanning-tree rstp forward-time seconds
Parameters seconds — Enter the number of seconds an interface waits in the Blocking or Learning States before moving to
the Forwarding state (4 to 30).
Default 15 seconds
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# spanning-tree rstp forward-time 16
Supported Releases 10.2.0E or later
236 Layer 2