Reference Guide
random-detect weight
Congures the exponential weight value used to calculate the average queue depth for the WRED prole.
Syntax
random-detect weight weight-value
Parameters weight-value — Enter a value for the weight (1 to 15).
Default Not congured
Command Mode WRED CONFIGURATION
Usage Information The no version of this command removes the weight factor from the WRED prole.
Example
OS10(config)# wred test_wred
OS10(config-wred)# random-detect weight 10
Supported Releases 10.4.0E(R1) or later
service-policy
Congures the input and output service policies.
Syntax
service-policy {input | output} [type {qos | queuing | network-qos}] policy-
map-name
Parameters
• input — Enter to assign a QoS policy to the interface input.
• output — Enter to assign a QoS policy to the interface output.
• qos — Enter to assign a qos type policy-map.
• queuing — Enter to assign the queuing type policy-map.
• network-qos — Enter to assign the network-qos type policy-map.
• policy-map-name — Enter the policy-map name (up to 32 characters).
Default Not congured
Command Mode INTERFACE
Usage Information Attach only one policy-map to the interface input and output for each qos and queuing policy-map type. You can
attach four service-policies to the system QoS — one each for qos, queueing, and network-qos type policy-
maps. When you congure service policies at the interface-level and system-level, the interface-level policy takes
precedence over the system-level policy.
Example
OS10(conf-if-eth1/1/7)# service-policy input type qos p1
Supported Releases 10.2.0E or later
set cos
Sets a cost of service (CoS) value to mark L2 802.1p (dot1p) packets.
Syntax
set cos cos-value
Quality of service 591