Reference Guide

Restore factory defaults
Reboots the system to ONIE Rescue mode to restore the ONIE-enabled device to factory defaults.
CAUTION: Restoring factory defaults erases any installed operating system and requires a long time to erase storage.
ONIE Rescue bypasses the installed operating system and boots the system into ONIE until you reboot the system. After ONIE Rescue
completes, the system resets and boots to the ONIE console.
1 Use the up and down arrows to select the ONIE: Rescue, then press Enter. The highlight entry (*) runs automatically in the operating
system.
+--------------------------------------+
|*ONIE: Install OS |
| ONIE: Rescue |
| ONIE: Uninstall OS |
| ONIE: Update ONIE |
| ONIE: Embed ONIE |
| ONIE: Diag ONIE |
+--------------------------------------+
2 Press Enter again to enable the console.
3 Use the onie-uninstall command to return to the default ONIE settings.
ONIE:/ # onie-uninstall
Erasing unused NOR flash region Erasing 128 Kibyte @ 20000 - 100% complete. Erasing internal
mass storage device: /dev/mmcblk0 (7832MB) Percent complete: 100%
SupportAssist
By default, SupportAssist is enabled. SupportAssist sends troubleshooting data securely to Dell Technical Support. SupportAssist does not
support automated email notication at the time of hardware fault alert, automatic case creation, automatic part dispatch, or reports.
To disable SupportAssist, use the eula-consent support-assist reject command.
688
Troubleshoot OS10