Users Guide

Table Of Contents
Usage
Information
If you enable trust, traffic obeys this trust map. default-dscp-trust is a reserved trust-map name.
The no version of this command returns the value to the default.
Example
OS10(config)# trust dscp-map dscp-trust1
Supported
Releases
10.3.0E or later
trust-map
Configures trust map on an interface or on a system QoS.
Syntax
trustmap {dot1p | dscp} {default | trust-map-name}
Parameters
dot1p Apply dot1p trust map.
dscp Apply dscp trust map.
default Apply default dot1p or dscp trust map.
trust-map-name Enter the name of trust map.
Default Disabled
Command Mode
INTERFACE
SYSTEM-QoS
Usage
Information
Use the show qos maps type [tc-queue | trust-map-dot1p | trust-map-dscp]
[trust-map-name] command to view the current trust mapping. You must change the trust map
only during no traffic flow. Verify the correct policy maps are applied. The no version of this command
returns the value to the default. The no version of this command removes the applied trust map from the
interface or system QoS.
Example
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# trust-map dot1p default
OS10(conf-if-eth1/1/10)# trust-map dot1p d1
OS10(config)# interface ethernet 1/1/2
OS10(conf-if-eth1/1/2)# trust-map dscp default
OS10(conf-if-eth1/1/2)# trust-map dscp d2
OS10(config)# system qos
OS10(config-sys-qos)# trust-map dot1p default
OS10(config-sys-qos)# trust-map dscp d2
Supported
Releases
10.4.1.0 or later
wred
Configures a weighted random early detection (WRED) profile.
Syntax
wred wred-profile-name
Parameters wred-profile-name Enter a name for the WRED profile.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the WRED profile.
1262 Quality of service