Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4128F-ON/S4128T-ON
201202203204205206207208209210
Table Of Contents
hardware-address 00:0c:29:ee:4c:f4
!
pool hostnetwork
lease infinite
network 100.1.1.0/24
!
pool host2
host 20.1.1.34
hardware-address 00:0c:29:aa:22:f4
View DHCP Information
Use the show ip dhcp binding command to view the DHCP binding table entries.
OS10# show ip dhcp binding
IP Address Hardware address Lease expiration Hostname
+--------------------------------------------------------------------------
11.1.1.254 00:00:12:12:12:12 Jan 27 2016 06:23:45
Total Number of Entries in the Table = 1
DHCP relay agent
A DHCP relay agent relays DHCP messages to and from a remote DHCP server, even if the client and server are on different IP
networks. You can configure the IP address of the remote DHCP server.
You can configure a device either as a DHCP server or a DHCP relay agent — but not both.
If routes are not leaked between VRFs, the DHCP relay agent supports multi-virtual routing and forwarding (VRF) instances.
The client-facing and server-facing interfaces must be in the same VRF.
The DHCPv6 relay agent performs the same role as that of a DHCP relay agent, but in an IPv6 network. The DHCP relay
agent forwards the DHCPv4/DHCPv6 messages from the configured interface to the DHCPv6 server as a unicast message. The
DHCP relay agent then forwards the server’s response to the client.
When you configure DHCPv6 relay on an interface, you must:
● Configure an IPv6 address on the interface.
● Ensure that the DHCPv6 server is reachable.
Option 82 for security
DHCP, as defined by RFC 2131, provides no authentication or security mechanisms. To ensure security, the DHCP relay agent
supports Option-82 with the Circuit ID sub-option, which is the printable name of the interface where the client request was
received.
This option secures all DHCP traffic that goes through a DHCP relay agent, and ensures that communication between the DHCP
relay agent and the DHCP server is not compromised.
The DHCP relay agent inserts Option 82 before forwarding DHCP packets to the DHCP server. The DHCP server includes
Option 82 back in its response to the relay agent. The relay agent uses this information to forward a reply out the interface on
which the request was received rather than flooding it on the entire VLAN. However, the relay agent removes Option 82 from
its DHCP responses before forwarding the responses to the client.
NOTE: Option 82 is supported, but not configurable.
System management 209