Users Guide

The following shows converting a port group from 25g-4x mode to 10g-4x mode:
OS10# configure terminal
OS10(config)# port-group 1/1/1
OS10(conf-pg-1/1/1)# mode Eth 10g-4x
OS10(conf-pg-1/1/1)# exit
OS10(config)# interface ethernet 1/1/1:1
OS10(conf-if-eth1/1/1:1)# speed
1000 Set speed to 1000 Mbps
10000 Set speed to 10000 Mbps
auto Automatic Settings (default)
OS10(conf-if-eth1/1/1:1)# speed 1000
L2 mode configuration
Each physical Ethernet interface uses a unique MAC address. Port-channels and VLANs use a single MAC address. By default,
all the interfaces operate in L2 mode. From L2 mode you can configure switching and L2 protocols, such as VLANs and
Spanning-Tree Protocol (STP) on an interface.
Enable L2 switching on a port interface in Access or Trunk mode. By default, an interface is configured in Access mode. Access
mode allows L2 switching of untagged traffic on a single VLAN (VLAN 1 is the default). Trunk mode enables L2 switching of
untagged traffic on the Access VLAN, and tagged traffic on one or more VLANs.
By default, native VLAN of a port is the default VLAN ID of the switch. You can change the native VLAN using the
switchport access vlan vlan-id command.
A Trunk interface carries VLAN traffic that is tagged using 802.1q encapsulation. If an Access interface receives a packet with
an 802.1q tag in the header that is different from the Access VLAN ID, it drops the packet.
By default, a trunk interface carries only untagged traffic on the Access VLAN. You must manually configure other VLANs for
tagged traffic.
1. Select one of the two available options:
● Configure L2 trunking in INTERFACE mode and the tagged VLAN traffic that the port can transmit. By default, a trunk
port is not added to any tagged VLAN. You must create a VLAN before you can assign the interface to it.
switchport mode trunk
switchport trunk allowed vlan vlan-id-list
● Reconfigure the access VLAN assigned to a L2 access or trunk port in INTERFACE mode.
switchport access vlan vlan-id
2. Enable the interface for L2 traffic transmission in INTERFACE mode.
no shutdown
L2 interface configuration
OS10(config)# interface ethernet 1/1/7
OS10(conf-if-eth1/1/7)# switchport mode trunk
OS10(conf-if-eth1/1/7)# switchport trunk allowed vlan 5,10
OS10(conf-if-eth1/1/7)# no shutdown
L3 mode configuration
Ethernet and port-channel interfaces are in L2 access mode by default. When you disable the L2 mode and then assign an IP
address to an Ethernet port interface, you place the port in L3 mode.
Configure one primary IP address in L3 mode. You can configure up to 255 secondary IP addresses on an interface. At least one
interface in the system must be in L3 mode before you configure or enter a L3–protocol mode, such as OSPF.
1. Remove a port from L2 switching in INTERFACE mode.
no switchport
252
Interfaces