Users Guide

Supported
Releases
10.4.3.0 or later
lldp receive
Enables or disables the LLDP packet reception on a specific interface.
Syntax
lldp receive
Parameters None
Default Not configured
Command Mode INTERFACE
Usage
Information
Enable LLDP globally on the system before using the lldp receive command. The no version of this
command disables the reception of LLDP packets.
Example
OS10(conf-if-eth1/1/3)# lldp receive
Supported
Releases
10.2.0E or later
lldp reinit
Configures the delay time in seconds for LLDP to initialize on any interface.
Syntax
lldp reinit seconds
Parameters seconds — Enter the delay timer value in seconds, from 1 to 10.
Default 2 seconds
Command Mode CONFIGURATION
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(config)# lldp reinit 5
Supported
Releases
10.2.0E or later
lldp timer
Configures the rate in seconds at which LLDP packets send to the peers.
Syntax
lldp timer seconds
Parameters seconds — Enter the LLDP timer rate in seconds, from 5 to 254.
Default 30 seconds
Command Mode CONFIGURATION
Usage
Information
The no version of this command sets the LLDP timer back to its default value.
Example
OS10(config)# lldp timer 25
Supported
Releases
10.2.0E or later
Layer 2 451