Users Guide

● link-aggregation — Enable the link aggregation TLV.
● vlan-name — Configure dot1 TLVs to send and receive the names of VLANs in LLDP frames.
Default Enabled. vlan-name is disabled.
Command Mode INTERFACE
Usage
Information
The link-aggregation parameter advertises link aggregation as a dot1 TLV in the LLDPDUs.
The vlan-name parameter advertises the names of VLANs in LLDP frames.
The no version of this command disables TLV transmissions.
Example (Port)
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv port-vlan-id
Example (Link
Aggregation)
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv link-aggregation
Example (VLAN
name)
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv vlan-name
Supported
Releases
10.2.0E or later
lldp tlv-select dot3tlv
Enables or disables the dot3 TLVs to transmit in LLDP packets.
Syntax
lldp tlv-select dot3tlv {macphy-config | max-framesize}
Parameters
● macphy-config — Enable the port VLAN ID TLV.
● max-framesize — Enable maximum frame size TLV.
Default Enabled
Command Mode INTERFACE
Usage
Information
The no version of this command disables TLV transmission.
Example
OS10(conf-if-eth1/1/3)# lldp tlv-select dot3tlv macphy-config
Supported
Releases
10.2.0E or later
lldp transmit
Enables the transmission of LLDP packets on a specific interface.
Syntax
lldp transmit
Parameters None
Default Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command disables the transmission of LLDP packets on a specific interface.
Example
OS10(conf-if-eth1/1/9)# lldp transmit
Supported
Releases
10.2.0E or later
Layer 2 453