Reference Guide
fibrechannel1/1/30:3
====================================
Supported Releases 10.3.1E or later
vfabric
Congures a virtual fabric (vfabric). Enable the F_Port before conguring a vfabric. You can congure only one vfabric in F_Port mode. The
vfabric becomes active only when you congure the vfabric with a valid VLAN and FC map. Do not use spanned VLAN as vfabric VLAN.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not congured
Command Mode CONFIGURATION
Usage Information
The no version of this command removes the vfabric. You can remove a vfabric only when it is not applied on any
interfaces.
Example
OS10(config)# vfabric 100
Supported Releases 10.3.1E or later
vfabric (interface)
Applies an existing vfabric to an Ethernet or FC interface.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not congured
Command Mode INTERFACE
Usage Information
The no version of this command removes the vfabric from the interface.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# vfabric 100
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# vfabric 200
Supported Releases 10.3.1E or later
vlan
Associate an existing VLAN ID to the vfabric to carry trac. Create the VLAN ID before associating it to the vfabric. Do not use spanned
VLAN as vfabric VLAN.
Syntax
vlan vlan-ID
Parameters vlan-ID — Enter an existing VLAN ID.
144 Fibre Channel