Reference Guide

Press <DEL> or <F2> to enter setup.
Welcome to GRUB!
GNU GRUB version 2.02~beta2+e4a1fe391
OS10-B
EDA-DIAG
ONIE Booting `OS10-A'
Loading OS10 ...
[ 3.883826] kvm: already loaded the other module
[ 3.967628] dummy-irq: no IRQ given. Use irq=N
[ 3.973212] mic_init not running on X100 ret -19
[ 3.980168] esas2r: driver will not be loaded because no ATTO esas2r devices were found
[ 4.021676] mtdoops: mtd device (mtddev=name/number) must be supplied
[ 5.092316] i8042: No controller found
[ 5.108356] fmc_write_eeprom fake-design-for-testing-f001: fmc_write_eeprom: no busid
passed, refusing all cards
[ 5.120111] intel_rapl: driver does not support CPU family 6 model 77
[ 4.226593] systemd-fsck[493]: OS10-SYSROOT1: clean, 23571/426544 files, 312838/1704960
blocks
Debian GNU/Linux 8 OS10 ttyS0
Dell EMC Networking Operating System (OS10)
OS10 login:
Manual installation
You can manually install an OS10 software image if a DHCP server is not available. If the IP address for the Management port (eth0) is not
automatically discovered, ONIE sets the IP address to 192.168.3.10. You must manually congure the Management port and congure
the software image le to start installation.
1 Save the OS10 software image on an SCP/TFTP/FTP server.
2 Power up the device and select ONIE Rescue for manual installation.
3 (Optional) Stop the DHCP discovery if the device boots to ONIE Install.
$ onie-discovery-stop
4 Congure the IP addresses on the Management port, where x.x.x.x represents your internal IP address. After you congure the
Management port, the response should be up.
$ ifconfig eth0 x.x.x.x netmask 255.255.0.0 up
5 Install the software on the device. The installation command accesses the OS10 software from the specied SCP, TFTP, or FTP URL,
creates partitions, veries installation, and reboots itself.
$ onie-nos-install image_filename location
For example, enter
ONIE:/ # onie-nos-install ftp://a.b.c.d/PKGS_OS10–Enterprise-x.x.xx.bin
Where a.b.c.d represents the location to download the image le from, and x.x.xx represents the version number of the software to
install.
The OS10 installer image creates several partitions, including OS10-A (active and default) and OS10-B (standby). After installation
completes, the system automatically reboots and loads OS10.
Install manually using USB drive
You can manually install the OS10 software image using USB media. Verify that the USB storage device supports a FAT or EXT2 le
system. For instructions on how to format a USB device in FAT or EXT2 format, see the accompanying Windows documentation for FAT
formatting or Linux documentation for FAT or EXT2 formatting.
1 Plug the USB storage device into the USB storage port on the device.
2 Power up the system to automatically boot with the ONIE: Rescue option.
26
Getting Started