Reference Guide

Parameters interface-type — Enter the interface type for a local monitoring session.
• ethernet node/slot/port[:subport] — Enter the Ethernet interface information as the destination.
• port-channel id-number — Enter a port-channel number as the destination (1 to 128).
• vlan vlan-id —Enter a VLAN ID as the destination (1 to 4093).
remote-vlan vlan-id—Enter a remote VLAN ID as the destination for RPM monitoring session (1 to 4093).
Default Not congured
Command Mode MONITOR-SESSION
Usage Information The no version of this command resets the value to the default.
Example
OS10(conf-mon-local-10)# destination interface port-channel 10
OS10(conf-mon-rpm-source-3)# destination remote-vlan 20
Supported Releases 10.2.0E or later
ow-based
Enables ow-based monitoring. The monitoring session can be one of the following: local, RPM, or ERPM.
Syntax
flow-based enable
Parameters None
Default Disabled
Command Mode MONITOR-SESSION
Usage Information The no version of this command disables the ow-based monitoring.
Example
OS10(conf-mon-local-1)# flow-based enable
OS10(conf-mon-rpm-source-2)# flow-based enable
OS10(conf-mon-erpm-source-3)# flow-based enable
Supported Releases 10.2.0E or later
ip
Congures the IP time to live (TTL) value and the dierentiated services code point (DSCP) value for the ERPM trac.
Syntax
ip {ttl ttl-number | dscp dscp-number}
Parameters
• ttl-number — Enter the TTL value (1 to 255)
• dscp-number — Enter the DSCP value (0 to 63).
Default
• TTL: 255
• DSCP: 0
Command Mode MONITOR-SESSION (ERPM)
Usage Information The no version of this command removes the TTL and the DSCP values congured.
Layer 2 263