Reference Guide

3 Congure an IPv4 or IPv6 address on the Management interface in INTERFACE mode.
ip address A.B.C.D/mask
ipv6 address A:B/prefix-length
4 Enable the Management interface in INTERFACE mode.
no shutdown
Congure Management interface
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# no ip address dhcp
OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24
OS10(conf-if-ma-1/1/1)# no shutdown
Management Route Conguration
To set up remote access to OS10, congure a management route after you assign an IPv4 or IPv6 address to the Management port. The
default management route is the path used by a Management port to communicate with a dierent network. Management routes are
separate from IPv4 and IPv6 routes and are only used to manage the system through the Management port.
management route 192.168.100.0/24 1.1.1.1
ip route 192.168.200.0/24 2.2.2.2
management route 192.168.300.0/24 managementethernet
ip route 192.168.400.0/24 interface ethernet 1/1/1
Before conguring the static IPv4 address for management interface port, remove the dynamic DHCP setting using the no ip address
dhcp
command.
Congure a management route to the network from which you access the system in CONFIGURATION mode. Repeat the command to
congure multiple routes for the Management interface.
management route {ipv4-address/mask | ipv6-address/prefix-length}
{forwarding-router-address | managementethernet}
• ipv4-address/mask — Enter an IPv4 network address in dotted-decimal format (A.B.C.D), then a subnet mask in /prex-length
format (/x).
• ipv6-address/prefix-length — Enter an IPv6 address in x:x:x:x::x format with the prex length in /x format (prex range is /0
to /128).
• forwarding-router-address — Enter the next-hop IPv4/IPv6 address of a forwarding router for network trac from the
Management port.
• managementethernet — Congures the Management port as the interface for the route, and forces the route to be associated
with the Management interface.
Congure management route
OS10(config)# management route 10.10.20.0/24 10.1.1.1
OS10(config)# management route 172.16.0.0/16 managementethernet
Congure user name and password
To set up remote access to OS10, create a new user name and password after you congure the management port and default route. The
user role is a mandatory entry.
Enter the password in clear text. It is converted to SHA-512 format in the running conguration. A password must have at least nine
alphanumeric and special characters, and at least ve dierent characters from the password previously used for the same username.
Getting Started
35