Reference Guide
weight
Assigns a default weight for routes from the neighbor interfaces.
Syntax
weight number
Parameters number—Enter a number as the weight for routes, from 1 to 4294967295.
Default 0
Command Mode ROUTER-BGP-NEIGHBOR
Usage Information The path with the highest weight value is preferred in the best-path selection process. The no version of this
command resets the value to the default.
Example
OS10(conf-router-bgp-neighbor)# weight 4096
Supported Releases 10.3.0E or later
Equal cost multi-path
ECMP is a routing technique where next-hop packet forwarding to a single destination occurs over multiple best paths. OS10 uses a
hashing algorithm to determine the next-hop when you enable ECMP. The hashing algorithm makes hashing decisions based on values in
various packet elds as well as some internal values.
• Congure the hash algorithm in CONFIGURATION mode.
hash-algorithm ecmp crc
Change hash algorithm
OS10(config)# hash-algorithm ecmp crc
Load balancing
RTAG7 is a hashing algorithm that load balances trac within a trunk group in a controlled manner. To eectively increase the bandwidth of
ECMP routes, trac is balanced across member links. The balancing is performed by using the RTAG7 hashing, which is designed to have
the member links used eectively as the trac prole gets more diverse.
The RTAG7 hash scheme generates a hash that consists of two parts:
• The rst part is primarily generated from packet headers to identify micro-ows in trac. By default, all listed parameters are enabled
for load balancing except the ingress port.
OS10# show load-balance
Load-Balancing Configuration For LAG and ECMP:
----------------------------------------------
IPV4 Load Balancing : Enabled
IPV6 Load Balancing : Enabled
MAC Load Balancing : Enabled
TCP-UDP Load Balancing : Enabled
Ingress Port Load Balancing : Disabled
IPV4 FIELDS : source-ip destination-ip protocol vlan-id l4-destination-port l4-source-port
IPV6 FIELDS : source-ip destination-ip protocol vlan-id l4-destination-port l4-source-port
MAC FIELDS : source-mac destination-mac ethertype vlan-id
TCP-UDP FIELDS: l4-destination-port l4-source-port
• The second part comes from static physical conguration such as ingress and egress port numbers.
You can change the hash eld to generate load balancing based on any parameters using the load-balance command.
Layer 3
355