Reference Guide
OS10 (config-openflow)# in-band-mgmt interface ethernet 1/1/1
OS10 (config-openflow)# no shutdown
Supported Releases 10.4.1 or later
max-backo
Congures the time interval, in seconds, that the logical switch instance waits after requesting a connection with the OpenFlow controller.
Syntax
max-backoff interval
Parameters interval—Enter the amount of time, in seconds, that the logical switch instance waits after it attempts to
establish a connection with the OpenFlow controller, from 1 to 65,535.
Default 8 seconds
Command Mode OPENFLOW SWITCH CONFIGURATION
Usage Information If the interval time lapses, the logical switch instance re-attempts to establish a connection with the OpenFlow
controller.
Example
OS10 (config)# openflow
OS10 (config-openflow)# switch of-switch-1
OS10 (config-openflow-switch)# max-backoff 25
OS10 (config-openflow-switch)#
Supported Releases 10.4.1 or later
mode openow-only
Enables OpenFlow-only mode on the switch.
Syntax
mode openflow-only
Parameters None
Default None
Command Mode OPENFLOW CONFIGURATION
Usage Information
Use this command to enable OpenFlow-only mode. This command reloads the switch and boots to OpenFlow-only
mode. This command deletes all L2 and L3 congurations. However, the system management and AAA
congurations are retained.
The no form of this command prompts you to reload the switch. If you enter yes, the switch deletes all OpenFlow
congurations, including the controller IP, port, certicates, and reloads, then returns to the Normal mode.
NOTE: For a list of available commands when the switch is in the OpenFlow-only mode, see CLI
commands available in the OpenFlow-only mode.
Example
OS10 (config-openflow)# mode openflow-only
OS10 (config-openflow)#
Supported Releases 10.4.1 or later
582 OpenFlow