Reference Guide

speed 32
vfabric 100
OS10# show interface fibrechannel 1/1/43:1
Fibrechannel 1/1/43:1 is up, FC link is up
Address is 14:18:77:20:8d:fc, Current address is 14:18:77:20:8d:fc
Pluggable media present, QSFP+ type is QSFP+ 4x(16GBASE FC SW)
Wavelength is 850
Receive power reading is 0.0
FC MTU 2188 bytes
LineSpeed 8G
Port type is F, Max BB credit is 1
WWN is 20:78:14:18:77:20:8d:cf
Last clearing of "show interface" counters: 00:02:32
Input statistics:
33 frames, 3508 bytes
0 class 2 good frames, 33 class 3 good frames
0 frame too long, 0 frame truncated, 0 CRC
1 link fail, 0 sync loss
0 primitive seq err, 0 LIP count
0 BB credit 0, 0 BB credit 0 packet drops
Output statistics:
33 frames, 2344 bytes
0 class 2 frames, 33 class 3 frames
0 BB credit 0, 0 oversize frames
6356027325 total errors
Rate Info:
Input 116 bytes/sec, 1 frames/sec, 0% of line rate
Output 78 bytes/sec, 1 frames/sec, 0% of line rate
Time since last interface status change: 00:00:24
Management interface
The Management interface provides OOB management access to the network device. You can congure the Management interface, but
the conguration options on this interface are limited. You cannot congure gateway addresses and IP addresses if it appears in the main
routing table, and proxy ARP is not supported on this interface.
1 Congure the Management interface in CONFIGURATION mode.
interface mgmt 1/1/1
2 By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode.
no ip address dhcp
3 Congure an IP address and mask on the Management interface in INTERFACE mode.
ip address A.B.C.D/prefix-length
4 Enable the Management interface in INTERFACE mode.
no shutdown
Congure management interface
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# no ip address dhcp
OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24
OS10(conf-if-ma-1/1/1)# no shutdown
VLAN interfaces
VLANs are logical interfaces and are, by default, in L2 mode. Physical interfaces and port-channels can be members of VLANs.
OS10 supports inter-VLAN routing. You can add IP addresses to VLANs and use them in routing protocols in the same manner that physical
interfaces are used.
Interfaces
85