Users Guide

Defaults
● bc committed-burst-size value is 200 KB for control plane and 100 KB for all other
class-map types
● be peak-burst-size value is 200 KB for control plane and 100 KB for all other class-map
types
Command Mode POLICY-MAP-CLASS-MAP
Usage
Information
If you do not provide the peak-rate pir values, the committed-rate cir values are taken as the pir
values. Only the ingress QoS policy type supports this command. For control-plane policing, the rate
values are in pps.
Example
OS10(conf-pmap-c-qos)# police cir 5 bc 30 pir 20 be 40
Supported
Releases
10.2.0E or later
policy-map
Enters QoS POLICY-MAP mode and creates or modifies a QoS policy-map.
Syntax
policy-map policy-map-name [type {qos | queuing | control-plane |
application | network-qos }]
Parameters
● policy-map-name — Enter a class name for the policy-map. A maximum of 32 characters.
● type — Enter the policy-map type.
○ qos — Create a qos policy-map type.
○ queuing — Create a queueing policy-map type.
○ control-plane — Create a control-plane policy-map type.
○ application — Create an application policy-map type.
○ network-qos — Create a network-qos policy-map type.
Defaults qos = class-map type and match-any = class-map filter
Command Mode CONFIGURATION
Usage
Information
The no version of this command deletes a policy-map.
Example
OS10(config)# policy-map p1
Example
(Queuing)
OS10(config)# policy-map type queuing p1
Supported
Releases
10.2.0E or later
priority
Sets the scheduler as a strict priority.
Syntax
priority
Parameters None
Default WDRR — when priority is mentioned, it moves to SP with default level 1.
Command Mode POLICY-MAP-CLASS-MAP
Usage
Information
If you use this command, bandwidth is not allowed. Only the egress QoS policy type supports this
command.
Example
OS10(config-pmap-c-que)# priority
Quality of service 1361