Users Guide

destination
Sets the destination where monitored traffic is sent to. The monitoring session can be local or RPM.
Syntax
destination {interface interface-type | remote-vlan vlan-id}
Parameters interface-type—Enter the interface type for a local monitoring session.
● ethernet node/slot/port[:subport]—Enter the Ethernet interface information as the
destination.
● port-channel id-number—Enter a port-channel number as the destination, from 1 to 128.
● vlan vlan-id—Enter a VLAN ID as the destination, from 1 to 4093.
remote-vlan vlan-id—Enter a remote VLAN ID as the destination for the RPM monitoring session,
from 1 to 4093.
Default Not configured
Command Mode MONITOR-SESSION
Usage
Information
The no version of this command resets the value to the default.
This command is introduced on the MX9116n and MX5108n with support for full-switch mode from the
Dell EMC SmartFabric OS release 10.4.0(R3S). Also supported in SmartFabric Services mode on the
MX9116n and MX5108n from the Dell EMC SmartFabric OS release 10.5.1.
Example
OS10(conf-mon-local-10)# destination interface port-channel 10
OS10(conf-mon-rpm-source-3)# destination remote-vlan 20
Supported
Releases
10.2.0E or later
flow-based
Enables flow-based monitoring. The monitoring session can be: local, RPM, or ERPM.
Syntax
flow-based enable
Parameters None
Default Disabled
Command Mode MONITOR-SESSION
Usage
Information
The no version of this command disables the flow-based monitoring.
This command is introduced on the MX9116n and MX5108n with support for full-switch mode from the
Dell EMC SmartFabric OS release 10.4.0(R3S). Also supported in SmartFabric Services mode on the
MX9116n and MX5108n from the Dell EMC SmartFabric OS release 10.5.1.
Example
OS10(conf-mon-local-1)# flow-based enable
OS10(conf-mon-rpm-source-2)# flow-based enable
OS10(conf-mon-erpm-source-3)# flow-based enable
Supported
Releases
10.2.0E or later
Layer 2 561