Reference Guide
Usage Information
The no version of this command removes the vfabric. You can remove a vfabric only when it is not applied on any
interfaces.
Example
OS10(config)# vfabric 100
Supported Releases 10.3.1E or later
vfabric (interface)
Applies an existing vfabric to an FC interface.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not congured
Command Mode INTERFACE
Usage Information
The no version of this command removes the vfabric from the FC interface.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# vfabric 100
Supported Releases 10.3.1E or later
vlan
Associate an existing VLAN ID to the vfabric to carry trac. Create the VLAN ID before associating it to the vfabric. Do not use spanned
VLAN as vfabric VLAN.
Syntax
vlan vlan-ID
Parameters vlan-ID — Enter an existing VLAN ID.
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command removes the VLAN ID from the vfabric.
Example
OS10(config)# interface vlan 1023
10OS10(conf-if-vl-1023)# exit
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# vlan 1023
Supported Releases 10.3.1E or later
Fibre channel 115