Reference Guide
Example
(Connected)
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# redistribute connected route-map dell2
Supported Releases 10.2.0E or later
router-id
Congures a xed router ID for the OSPF process.
Syntax
router-id ip-address
Parameters ip-address — Enter the IP address of the router as the router ID.
Default Not congured
Command Mode ROUTER-OSPF
Usage Information Congure an arbitrary value in the IP address format for each router. Each router ID must be unique. Use the xed
router ID for the active OSPF router process. Changing the router ID brings down the existing OSPF adjacency.
The new router ID is eective at the next reload. The no version of this command disables the router ID
conguration.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# router-id 10.10.1.5
Supported Releases 10.2.0E or later
router ospf
Enters Router OSPF mode and congures an OSPF instance.
Syntax
router ospf instance-number
Parameters instance-number—Enter a router OSPF instance number, from 1 to 65535.
Default Not congured
Command Mode CONFIGURATION
Usage Information Assign an IP address to an interface before using this command. The no version of this command deletes an OSPF
instance.
Example
OS10(config)# router ospf 10
Supported Releases 10.2.0E or later
show ip ospf
Displays OSPF instance conguration information.
Syntax
show ip ospf [instance-number]
Parameters instance-number — View OSPF information for a specied instance number (1 to 65535)
Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# show ip ospf 10
Routing Process ospf 10 with ID 111.2.1.1
Layer 3 309