Reference Guide
Command Mode CONFIGURATION
Usage Information If trust is enabled, trac obeys the dot1p map. default-dot1p-trust is a reserved trust-map name. The no
version of this command returns the value to the default.
Example
OS10(config)# trust dot1p-map map1
OS10(config-tmap-dot1p-map)# qos-group 4 dot1p 5
Supported Releases 10.3.0E or later
trust dscp-map
Creates user-dened trust map for dscp ows.
Syntax
trust dscp-map map-name
Parameters map-name — Enter the name of the dscp trust map (up to 32 characters).
Default Not congured
Command Mode CONFIGURATION
Usage Information default-dscp-trust is a reserved trust-map name. If trust is enabled, trac obeys this trust map. The no
version of this command returns the value to the default.
Example
OS10(config)# trust dscp-map dscp-trust1
Supported Releases 10.3.0E or later
qos-map trac-class
Creates user-dened trust map for queue mapping.
Syntax
qos-map traffic-class map-name
Parameters map-name — Enter the name of the queue trust map (up to 32 characters).
Default Not congured
Command Mode CONFIGURATION
Usage Information The trac class will route all trac to the mapped queue if applied on the interface- or system-level. The no
version of this command returns the value to the default.
Example
OS10(config)# qos-map traffic-class queue-map1
OS10(config-qos-map)# queue 1 qos-group 5
OS10(config-qos-map)# queue 2 qos-group 6
OS10(config-qos-map)# queue 3 qos-group 7
OS10(config-qos-map)#
Supported Releases 10.3.0E or later
trust-map
Applies a dot1p or dscp trac class to a queue trust map.
Syntax
trust {dot1p | dscp} trust-map-name
520 Quality of service