Reference Guide
Parameters
• dot1p— Applies a dot1p trust map.
• dscp—Applies a dscp trust map.
Default Disabled
Command Mode
SYSTEM-QOS
INTERFACE
Usage Information Use the show qos maps type [tc-queue | trust-map-dot1p | trust-map-dscp] [string]
command to view the current trust mapping. You should change the trust map only during no trac ow, and
verify the correct policy maps are applied. The no version of this command returns the value to the default.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# trust-map dscp dscp-trustmap1
Supported Releases 10.3.0E or later
Quality of service 521