Reference Guide

Default None
Command Mode EXEC
Usage
Information
To view the ports that belong to each port group, use the show port-group command. To configure a
port group, enter the port-group command.
Example:
S4148U-ON
OS10(config)# show port-group
port-group mode ports
1/1/1 Eth 10g-4x 1 2 3 4
1/1/2 FC 16g-2x 5 6 7 8
1/1/3 FC 16g-2x 9 10 11 12
1/1/4 FC 16g-2x 13 14 15 16
1/1/5 FC 16g-2x 17 18 19 20
1/1/6 FC 16g-2x 21 22 23 24
1/1/7 Eth 100g-1x 25
1/1/8 Eth 40g-1x 26
1/1/9 Eth 100g-1x 29
1/1/10 Eth 40g-1x 30
Supported
Releases
10.3.1E or later
show switch-operating-mode
Displays the current operating mode of a supported switch.
Syntax
show switch-operating-mode
Parameters None
Command Mode EXEC
Usage
Information
Some OS10 switches operate in Full Switch and SmartFabric modes. The default is Full Switch mode.
Example
OS10# show switch-operating-mode
Switch-Operating-Mode : Smart Fabric Mode
Supported
Releases
10.4.0E(R3) or later
show switch-port-profile
Displays the current and default port profile on a switch.
Syntax
show switch-port-profile node/slot
Parameters
● node/slot — Enter the switch information. For a standalone switch, enter 1/1.
Default
profile-1
Command Mode EXEC
Usage
Information
A switch-port profile determines the available front-panel ports and breakout modes on Ethernet and
unified ports. To display the current port profile, enter the show switch-port-profile command.
To reset the switch to the default port profile, enter the no switch-port-profile node/slot
command.
Example
OS10(config)# show switch-port-profile 1/1
| Node/Unit | Current | Next-boot | Default |
|-------------+-------------------+-------------------|
| 1/1 | profile-2 | profile-2 | profile-1 |
110 Interfaces