Reference Guide

Usage
Information
The no version of this command disables FIP snooping on the VLAN.
You can enable FIP snooping on a VLAN only after enabling the FIP snooping feature globally using the
feature fip-snooping command. OS10 supports FIP snooping on a maximum of 12 VLANs.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping enable
Supported
Releases
10.4.0E(R1) or later
fip-snooping fc-map
Configure the FC map value for specific VLAN.
Syntax
fip-snooping fc-map fc-map
Parameters fc-map — Enter the FC map ID, ranging from 0xefc00 to 0xefcff.
Defaults Not configured
Command Mode VLAN INTERFACE
Usage
Information
The no version of this command disables the FC map configuration.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping fc-map 0xEFC64
Supported
Releases
10.4.0E(R1) or later
fip-snooping port-mode fcf
Sets the FIP snooping port mode to FCF for interfaces.
Syntax
fip-snooping port-mode fcf
Parameters None
Defaults ENode port mode
Command Mode INTERFACE
Usage
Information
By default, the port mode of an interface is set to ENode. Use this command to change the port mode to
FCF. You can set the port mode to FCF only after enabling the FIP snooping feature.
The no version of this command resets the port mode to ENode.
Example
OS10(config)# interface ethernet 1/1/32
OS10(conf-if-eth1/1/32)# fip-snooping port-mode fcf
Supported
Releases
10.4.0E(R1) or later
FCoE commands
The following commands are supported on all the three modes: F_Port, NPG, and FSB.
Fibre Channel
137