Reference Guide

Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout quiet-period 120
Supported
Releases
10.2.0E or later
dot1x timeout re-authperiod
Sets the number of seconds between re-authentication attempts.
Syntax
dot1x timeout re-authperiod seconds
Parameters re-authperiod seconds — Enter the number of seconds for the 802.1X re-authentication timeout (1
to 65535).
Default 3600 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout re-authperiod 7200
Supported
Releases
10.2.0E or later
dot1x timeout server-timeout
Sets the number of seconds that the device waits before retransmitting a packet to the authentication server.
Syntax
dot1x timeout server-timeout seconds
Parameters server-timeout seconds — Enter the number of seconds for the 802.1X server timeout (1 to
65535).
Default 30 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x server-timeout 60
Supported
Releases
10.2.0E or later
dot1x timeout supp-timeout
Sets the number of seconds that the device waits for the supplicant to respond to an EAP request frame before the device
retransmits the frame.
Syntax
dot1x timeout supp-timeout seconds
Parameters supp-timeout seconds — Enter the number of seconds for the 802.1X supplicant timeout (1 to
65535).
Default 30 seconds
Layer 2 153