Reference Guide

Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout supp-timeout 45
Supported
Releases
10.2.0E or later
dot1x timeout tx-period
Sets the number of seconds that the device waits for a response to an EAP-request/identity frame from the supplicant before
retransmitting the request.
Syntax
dot1x timeout tx-period seconds
Parameters tx-period seconds — Enter the number of seconds for the 802.1X transmission timeout (1 to
65535).
Default 60 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout tx-period 120
Supported
Releases
10.2.0E or later
show dot1x
Displays global 802.1X configuration information.
Syntax
show dot1x
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
None
Example
OS10# show dot1x
PAE Capability: Authenticator only
Protocol Version: 2
System Auth Control: Enable
Auth Server: Radius
Supported
Releases
10.2.0E or later
show dot1x interface
Displays 802.1X configuration information.
Syntax
show dot1x interface ethernet node/slot/port[:subport]
Parameters ethernet node/slot/port[:subport] — Enter the Ethernet interface information.
154 Layer 2