Reference Guide

Example
OS10(conf-if-eth1/1/5)# lldp med network-policy add 1
Supported
Release
10.2.0E or later
lldp med tlv-select
Configures the LLDP-MED TLV type to transmit or receive.
Syntax
lldp med tlv-select {network—policy | inventory}
Parameters
● network-policy — Enable or disable the port description TLV.
● inventory — Enable or disable the system TLV.
Default Enabled
Command Mode INTERFACE
Usage
Information
None
Example
OS10(conf-if-eth1/1/3)# lldp med tlv-select network-policy
Supported
Releases
10.2.0E or later
lldp receive
Enables or disables the LLDP packet reception on a specific interface.
Syntax
lldp receive
Parameters None
Default Not configured
Command Mode INTERFACE
Usage
Information
Enable LLDP globally on the system before using the lldp receive command. The no version of this
command disables the reception of LLDP packets.
Example
OS10(conf-if-eth1/1/3)# lldp receive
Supported
Releases
10.2.0E or later
lldp reinit
Configures the delay time (in seconds) for LLDP to initialize on any interface.
Syntax
lldp reinit seconds
Parameters seconds — Enter the delay timer value in seconds (1 to 10).
Default 2 seconds
Command Mode CONFIGURATION
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(config)# lldp reinit 5
184 Layer 2