Reference Guide

Usage
Information
The no version of this command removes the description text.
Example
OS10(conf-mon-local-1)# description remote
OS10(conf-mon-rpm-source-5)# description "RPM Sesssion"
OS10(conf-mon-erpm-source-10)# description "ERPM Session"
Supported
Releases
10.2.0E or later
destination (Port Monitoring)
Sets the destination where monitored traffic is sent to. The monitoring session can be local or RPM.
Syntax
destination {interface interface-type | remote-vlan vlan-id}
Parameters interface-type — Enter the interface type for a local monitoring session.
● ethernet node/slot/port[:subport] — Enter the Ethernet interface information as the
destination.
● port-channel id-number — Enter a port-channel number as the destination (1 to 128).
● vlan vlan-id —Enter a VLAN ID as the destination (1 to 4093).
remote-vlan vlan-id—Enter a remote VLAN ID as the destination for RPM monitoring session (1 to
4093).
Default Not configured
Command Mode MONITOR-SESSION
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-mon-local-10)# destination interface port-channel 10
OS10(conf-mon-rpm-source-3)# destination remote-vlan 20
Supported
Releases
10.2.0E or later
flow-based
Enables flow-based monitoring. The monitoring session can be one of the following: local, RPM, or ERPM.
Syntax
flow-based enable
Parameters None
Default Disabled
Command Mode MONITOR-SESSION
Usage
Information
The no version of this command disables the flow-based monitoring.
Example
OS10(conf-mon-local-1)# flow-based enable
OS10(conf-mon-rpm-source-2)# flow-based enable
OS10(conf-mon-erpm-source-3)# flow-based enable
250 Layer 2