Reference Guide

Example
OS10(conf-if-eth1/1/1)# ip ospf network broadcast
Supported
Releases
10.2.0E or later
ip ospf passive
Configures an interface as a passive interface and suppresses routing updates (both receiving and sending) to the passive
interface.
Syntax
ip ospf passive
Parameters None
Default Not configured
Command Mode INTERFACE
Usage
Information
You must configure the interface before setting the interface to Passive mode. The no version of the this
command disables the passive interface configuration.
Example
OS10(conf-if-eth1/1/6)# ip ospf passive
Supported
Releases
10.2.0E or later
ip ospf priority
Sets the priority of the interface to determine the designated router for the OSPF network.
Syntax
ip ospf priority number
Parameters number — Enter a router priority number (0 to 255).
Default 1
Command Mode INTERFACE
Usage
Information
When two routers attached to a network attempt to become the designated router, the one with the
higher router priority takes precedence. The no version of this command resets the value to the default.
Example
OS10(conf-if-eth1/1/6)# ip ospf priority 4
Supported
Releases
10.2.0E or later
ip ospf retransmit-interval
Sets the retransmission time between lost LSAs for adjacencies belonging to the interface.
Syntax
ip ospf retransmit-interval seconds
Parameters seconds — Enter a value in seconds as the interval between retransmission (1 to 3600).
Default 5 seconds
Command Mode INTERFACE
Usage
Information
Set the time interval to a number large enough to avoid unnecessary retransmission. The no version of
this command resets the value to the default.
Example
OS10(conf-if-eth1/1/6)# ip ospf retransmit-interval 20
Layer 3 399