Reference Guide

Defaults Not configured
Command Mode INTERFACE
Usage
Information
None
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ip policy route-map map1
Supported
Releases
10.3.0E or later
route-map pbr-statistics
Enables counters for PBR statistics.
Syntax
route-map [map-name] pbr-statistics
Parameters map-name—Enter the name of a configured route-map (up to 140 characters).
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
None
Example
OS10(config)# route-map map1 pbr-statistics
Supported
Releases
10.3.0E or later
set next-hop
Sets an IPv4 or IPv6 next-hop address for policy-based routing.
Syntax
set {ip | ipv6} next-hop address
Parameters address — Enter the next-hop IPv4 or IPv6 address.
Defaults Not configured
Command Mode ROUTE-MAP
Usage
Information
None
Example
OS10(conf-route-map)# set ip next-hop 10.10.10.10
Supported
Releases
10.3.0E or later
set next-hop track
Sets the next-hop IPv4 or IPv6 address to track the PBR object.
Syntax
set {ip | ipv6} next-hop address track track-id
Parameters
● address—Enter an IPv4 or IPv6 address.
● track-id—(Optional) Enter the track ID of the PBR object.
Defaults Not configured
444 Layer 3