Reference Guide

● Broadcast — Enter b-node.
● Hybrid — Enter h-node.
● Mixed — Enter m-node.
● Peer-to-peer — Enter p-node.
Default Hybrid
Command Mode DHCP-POOL
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-dhcp-Dell)# netbios-node-type h-node
Supported
Releases
10.2.0E or later
network
Configures a range of IPv4 or IPv6 addresses in the address pool.
Syntax
network address/mask
Parameters address/mask — Enter a range of IP addresses and subnet mask in A.B.C.D/x or A::B/x format.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
Use this command to configure a range of IPv4 or IPv6 addresses.
Example
OS10(config-dhcp-Dell)# network 20.1.1.1/24
Supported
Releases
10.2.0E or later
pool
Creates an IP address pool name.
Syntax
pool pool-name
Parameters pool-name — Enter the DHCP server pool name.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
Use this command to create an IP address pool name.
Example
OS10(conf-dhcp)# pool Dell
OS10(conf-dhcp-Dell)#
Supported
Releases
10.2.0E or later
range
Configures a range of IP addresses.
Syntax
range {ip-address1 [ip-address2]}
System management 473