Reference Guide

downstream
Adds an interface or a range of interfaces as a downstream interface to the uplink-state group.
Syntax
downstream {interface-type | interface-range}
Parameters
● interface-type — Enter the interface type as Ethernet or port-channel.
● interface-range — Enter the range of interfaces.
Default None
Command Mode UPLINK-STATE-GROUP
Usage
Information
You cannot assign an interface that is already a member of an uplink-state group to another group. The
no version of this command removes the interface from the uplink-state group.
Example
OS10(config)# uplink-state-group 1
OS10(conf-uplink-state-group-1)# downstream ethernet 1/1/1
Supported
Releases
10.4.0E(R3) or later
downstream auto-recover
Enables auto-recovery of the disabled downstream interfaces.
Syntax
downstream auto-recover
Parameters None
Default Enabled
Command Mode UPLINK-STATE-GROUP
Usage
Information
The no version of this command disables the auto-recovery of downstream interfaces.
Example
OS10(config)# uplink-state-group 1
OS10(conf-uplink-state-group-1)# no downstream auto-recover
Supported
Releases
10.4.1.0 or later
downstream disable links
Configures the number of downstream interfaces to disable when an upstream interface in the uplink-state group goes down.
Syntax
downstream disable links{number | all}
Parameters
● number—Enter the number of downstream interfaces to disable, from 1 to 1024.
● all—Enter all to disable all the downstream interfaces.
Default Not configured
Command Mode UPLINK-STATE-GROUP
Usage
Information
The no version of this command reverts the settings to the default state.
Example
OS10(config)# uplink-state-group 1
OS10(conf-uplink-state-group-1)# downstream disable links 2
Supported
Releases
10.4.1.0 or later
522 System management