Reference Guide

Default Not configured
Command Mode IPV4-ACL
Usage
Information
The no version of this command removes the filter.
Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# permit udp any any capture session 1
Supported
Releases
10.2.0E or later
permit (IPv6)
Configures a filter to allow packets with a specific IPv6 address.
Syntax
permit [protocol-number | icmp | ipv6 | tcp | udp] [A::B | A::B/x | any |
host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | dscp
value | fragment]
Parameters
● protocol-number — (Optional) Enter the protocol number identified in the IPv6 header, from 0 to
255.
● icmp — (Optional) Enter the ICMP address to permit.
● ipv6 — (Optional) Enter the IPv6 address to permit.
● tcp — (Optional) Enter the TCP address to permit.
● udp — (Optional) Enter the UDP address to permit.
● A::B — Enter the IPv6 address in hexadecimal format separated by colons.
● A::B/x — Enter the number of bits that must match the IPv6 address.
● any — (Optional) Set all routes which are subject to the filter:
○ capture — (Optional) Capture packets the filter processes.
○ dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
○ fragment — (Optional) Use ACLs to control packet fragments.
● host ip-address — (Optional) Enter the IPv6 address to use a host address only.
Default Not configured
Command Mode IPV6-ACL
Usage
Information
The no version of this command removes the filter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# permit udp any any capture session 1
Supported
Releases
10.2.0E or later
permit (MAC)
Configures a filter to allow packets with a specific MAC address.
Syntax
permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn
[00:00:00:00:00:00] | any} [protocol-number | capture | cos | vlan]
Parameters
● nn:nn:nn:nn:nn:nn — Enter the MAC address.
● 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not
enter a mask, a mask of 00:00:00:00:00:00 applies.
● any — (Optional) Set which routes are subject to the filter:
Access Control Lists 591