Reference Guide

● log-debug — Set to debug messages.
Default Log-notice
Command Mode CONFIGURATION
Usage
Information
None
Example
OS10(config)# logging monitor severity log-info
Supported
Releases
10.2.0E or later
logging server
Configures the remote syslog server.
Syntax
logging server {hostname | ipv4–address | ipv6–address} [severity severity-
level | vrf management [severity severity-level] [tcp port-number | udp
port-number]
Parameters
● hostname | ipv4–address | ipv6–address — (Optional) Enter either the hostname or
IPv4/IPv6 address of the logging server.
● vrf management — (Optional) Configure the logging server for the management VRF instance.
● severity-level — (Optional) Set the logging threshold severity:
○ log-emerg — System as unusable.
○ log-alert — Immediate action is needed.
○ log-crit — Critical conditions.
○ log-err — Error conditions.
○ log-warning — Warning conditions.
○ log-notice — Normal but significant conditions (default).
○ log-info — Informational messages.
○ log-debug — Debug messages.
● tcp port-number — (Optional) Send syslog messages over TCP to a specified port on a remote
logging server (1-65535).
● udp port-number — (Optional) Send syslog messages over UDP to a specified port on a remote
logging server (1-65535; default 514).
Defaults
System messages of the log-notice security level and lower are generated.
Syslog messages are sent over UDP to port 514 on a remote logging server.
Command Mode CONFIGURATION
Usage
Information
Starting from 10.3.0E or later, this command supports IPv6 addresses. The previous versions support only
IPv4 addresses. The no version of this command deletes the syslog server.
Example
OS10(config)# logging server dell.com severity log-info
OS10(config)# logging server fda8:6c3:ce53:a890::2 tcp 1468
OS10(config)# logging server dell.com vrf management severity log-debug
Supported
Releases
10.2.0E or later
Troubleshoot OS10 807