Users Guide
Table Of Contents
- Dell EMC SmartFabric OS10 Installation, Upgrade, and Downgrade Guide
- About this guide
- Installing SmartFabric OS10
- Preparing for an upgrade
- Supported upgrade paths—Full Switch mode deployments
- Supported upgrade paths—SFS mode in Dell EMC VxRail deployments
- Supported upgrade paths—SFS mode in Dell EMC PowerEdge MX deployments
- Upgrading other related hardware and software components
- Prerequisites for SmartFabric OS10 deployments
- Prerequisites for solution deployments
- Upgrading OS10 software
- Downgrading OS10 software
- Frequently asked questions
Preparing for an upgrade
This chapter provides you a list of prerequisites that you must ensure are met before you upgrade the SmartFabric OS10 nodes
in your network. Review the following information carefully and plan for your upgrade:
● Supported upgrade paths for Full Switch Mode deployments
● Supported upgrade paths for SFS Mode in Dell EMC VxRail deployments
● Supported upgrade paths for SFS mode in Dell EMC PowerEdge MX deployments
● Other hardware and software component upgrades
● Prerequisites for SmartFabric OS10 deployments
● Prerequisites for solution deployments
Supported upgrade paths—Full Switch mode
deployments
The following table lists the supported upgrade paths for SmartFabric OS10 in Full Switch mode deployments.
NOTE:
Follow the validated upgrade paths listed in this table before you upgrade to the latest release. Ensure that you back
up the configuration data and license files in an external storage. The notation A » B indicates that OS10 supports direct
upgrade from Release A to Release B.
NOTE: For instructions about upgrading OS10 on a pair of VLT nodes, see Upgrade OS10 on VLT nodes with minimal traffic
loss.
NOTE: If you are deploying an OS10 switch that has a factory-loaded older version of the OS10 software, Dell Technologies
recommends that you download the latest version of the software and perform a fresh installation. See Installing
SmartFabric OS10 section for details.
Table 3. Full Switch mode deployments (continued)
Release Supported upgrade paths for non-VLT
deployments
Supported upgrade paths for VLT deployments
10.5.1.x You can directly upgrade to 10.5.2.x You can directly upgrade to 10.5.2.x
10.5.0.x You can directly upgrade to 10.5.2.x
● 10.5.0.5 or earlier » 10.5.0.6 » 10.5.2.x
● 10.5.0.6 or later » 10.5.2.x
10.4.3.x
You can directly upgrade to:
● 10.5.0.x
● 10.5.1.x
To upgrade to the latest release:
10.4.3.x » 10.5.1.x » 10.5.2.x
10.4.3.x » 10.5.0.6 » 10.5.2.x
10.4.2.x
You can directly upgrade to:
● 10.4.3.x
● 10.5.0.x
To upgrade to the latest release:
10.4.2.x » 10.5.0.x » 10.5.2.x
10.4.2.x » 10.5.0.6 » 10.5.2.x
10.4.1.x
You can directly upgrade to:
10.4.1.x » 10.4.3.x » 10.5.0.6 » 10.5.2.x
3
14 Preparing for an upgrade