Users Guide
Table Of Contents
- Dell EMC SmartFabric OS10 Installation, Upgrade, and Downgrade Guide
- About this guide
- Installing SmartFabric OS10
- Preparing for an upgrade
- Supported upgrade paths—Full Switch mode deployments
- Supported upgrade paths—SFS mode in Dell EMC VxRail deployments
- Supported upgrade paths—SFS mode in Dell EMC PowerEdge MX deployments
- Upgrading other related hardware and software components
- Prerequisites for SmartFabric OS10 deployments
- Prerequisites for solution deployments
- Upgrading OS10 software
- Downgrading OS10 software
- Frequently asked questions
OS10(configure-router-bgpv4-af)# end
OS10#
2. Follow the VLT min-loss upgrade procedure outlined above.
3. Remove the route-map on both VLT peers one after the other.
OS10(config)# router bgp <AS-Number>
OS10(config-router-bgp-<AS-Number)# address-family ipv4 unicast
OS10(configure-router-bgpv4-af)# no network <prefix> route-map set_origin
OS10(configure-router-bgpv4-af)# network <prefix>
OS10(configure-router-bgpv4-af)#
Upgrade from OS9 to OS10
When you upgrade an OS9 switch to OS10, the first step is to uninstall OS9 using the ONIE: Uninstall OS option on the ONIE
boot menu. The Uninstall option deletes the OS9 configuration and all disk partitions. After you uninstall OS9, follow the steps to
install OS10 on a Dell EMC ONIE device:
1. Uninstall existing OS.
2. Download an OS10 image.
3. Install OS10 using ONIE.
4. Log in to an OS10 switch.
5. Download and install an OS10 license.
Upgrading OS10 software 27