Concept Guide
Table Of Contents
- Dell EMC SmartFabric Services User Guide Release 1.0
- About this guide
- SFS fundamentals
- Setting up SFS
- Deploying and managing a fabric
- Access fabric setup options
- Update default fabric, switch names, and descriptions
- Create uplink for external network connectivity
- Breakout switch ports
- Configure jump host
- Update network configuration
- Onboard a server onto the fabric
- Edit default fabric settings
- Restore fabric configuration
- Manage network profiles
- Manage routing profiles
- Access fabric setup options
- SFS with VxRail
- SFS with PowerEdge MX
- SFS for Isilon/PowerScale back-end fabric
- SFS commands
- smartfabric l3fabric enable
- smartfabric vlti
- show logging smartfabric
- show smartfabric cluster
- show smartfabric cluster member
- show smartfabric configured-server
- show smartfabric configured-server configured-server-interface
- show smartfabric details
- show smartfabric discovered-server
- show smartfabric discovered-server discovered-server-interface
- show smartfabric networks
- show smartfabric nodes
- show smartfabric personality
- show smartfabric uplinks
- show smartfabric upgrade-status
- show smartfabric validation-errors
- show switch-operating-mode
- Appendix
Edit default fabric settings
Use the following procedure to edit the default fabric settings:
1. Click Home > Edit Default Fabric Settings.
2. Change the values of the default settings as required.
3. Click OK. The changed settings are applied only after a reboot. The system prompts for confirmation to continue. After you
click OK, all the switches in the network fabric reload to apply the fabric setting changes.
Restore fabric configuration
Restore the SFS configurations on a fabric to a known good configuration with the backup configuration file stored on your
external device. Use the following procedure to restore:
1. Click Home > Restore.
Deploying and managing a fabric
33