Connectivity Guide

Command Mode INTERFACE
Usage Information Change the LACP timer rate to modify the duration of the LACP timeout. The no version of this command resets
the rate to the default value.
Example
OS10(conf-range-eth1/1/7-1/1/8)# lacp rate fast
Supported Releases 10.2.0E or later
lacp system-priority
Sets the system priority of the device for LACP.
Parameters priority — Enter the priority value for physical interfaces (0 to 65535).
Default 32768
Command Mode CONFIGURATION
Usage Information Each device that runs LACP has an LACP system priority value. LACP uses the system priority with the MAC
address to form the system ID and also during negotiation with other systems. The system ID is unique for each
device. The no version of this command resets the system priority to the default value.
Example
OS10(config)# lacp system-priority 32768
Supported Releases 10.2.0E or later
show lacp counter
Displays information about LACP statistics.
Syntax
show lacp counter [interface port-channel channel-number]
Parameters
• interface port-channel — (Optional) Enter the interface port-channel.
• channel-number — (Optional) Enter the LACP channel group number (1 to 128).
Default Not congured
Command Mode EXEC
Usage Information All channel groups display if you do not enter the channel-number parameter.
Example
OS10# show lacp counter interface port-channel 1
LACPDUs Marker Marker Response LACPDUs
Port Sent Recv Sent Recv Sent Recv Pkts Err
----------------------------------------------------------------
port-channel1
Ethernet1/1 554 536 0 0 0 0 0
Ethernet1/2 527 514 0 0 0 0 0
Ethernet1/3 535 520 0 0 0 0 0
Ethernet1/4 515 502 0 0 0 0 0
Ethernet1/5 518 505 0 0 0 0 0
Ethernet1/6 540 529 0 0 0 0 0
Ethernet1/7 541 530 0 0 0 0 0
Ethernet1/8 547 532 0 0 0 0 0
Ethernet1/9 544 532 0 0 0 0 0
Ethernet1/10 513 501 0 0 0 0 0
Ethernet1/11 497 485 0 0 0 0 0
Ethernet1/12 493 486 0 0 0 0 0
Layer 2 187