Connectivity Guide

Table Of Contents
3 Assign the interface to a non-default VRF.
INTERFACE CONFIGURATION
ip vrf forwarding vrf-test
Before assigning an interface to a VRF instance, ensure that no IP address is congured on the interface.
4 Assign an IPv4 address to the interface.
INTERFACE CONFIGURATION
ip address 10.1.1.1/24
5 Assign an IPv6 address to the interface.
INTERFACE CONFIGURATION
ipv6 address 1::1/64
You can also auto congure an IPv6 address using the ipv6 address autoconfig command.
NOTE: Before conguring any routing protocol in a VRF instance, you need to rst assign an IP address to at least one
of the interfaces assigned to the VRF instance on which you want to congure routing protocols.
Assigning a loopback interface to a non-default VRF instance
After creating a non-default VRF instance you can associate a loopback interface to the VRF instance that you created.
To assign a loopback interface to a non-default VRF, perform the following steps:
1 Enter the loopback interface that you want to assign to a non-default VRF instance.
CONFIGURATION
interface loopback 5
2 Assign the interface to a non-default VRF.
INTERFACE CONFIGURATION
ip vrf forwarding vrf-test
Before assigning a n interface to a VRF instance, ensure that no IP address is congured on the interface.
3 Assign an IPv4 address to the interface.
INTERFACE CONFIGURATION
ip address 10.1.1.1/24
4 Assign an IPv6 address to the interface.
INTERFACE CONFIGURATION
ipv6 address 1::1/64
You can also auto congure an IPv6 address using the ipv6 address autoconfig command.
Layer 3
285