Setup Guide

S4100–ON Series installation

To install the S4100–ON Series, Dell recommends completing the installation procedures in the order presented in this section.

Always handle the S4100–ON Series switch and its components with care. Avoid dropping the system or any eld replaceable units (FRUs).

NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when

handling the S4100–ON Series switch and its components. As with all electrical devices of this type, take all the necessary safety

precautions to prevent injury when installing this system.

NOTE: For more information, see the

Open Networking Hardware Diagnostic Guide

Topics:

• Unpack the system

• Unpack

• Rack or cabinet installation

• ReadyRails installation

• 1U Tool-less mount installation

• Two-post ush-mount installation

• Two-post center-mount installation

• Four-post threaded installation

• S4100-ON Series system installation

• 1U front-rack installation

• Optics installation

• Optics removal

• System power-up

• After system installation

Unpack the system

NOTE

: Before unpacking the system, inspect the container and immediately report any evidence of damage.

When unpacking the S4100–ON Series switch, make sure that the following items are included:

• One S4100–ON Series switch

• One RJ-45 to DB-9 female cable

• Two sets of rail kits, no tools required

• Two PSUs

• Three or four fan units

• Two country- and region-specic AC power cords

• Dell Networking S4100–ON Series Setup Guide

• Safety and Regulatory Information

• Warranty and Support Information

S4100–ON Series installation 9