Specifications
Table Of Contents
- Open Networking Hardware Diagnostic Guide June 2018
- About this guide
- ONIE and Dell EMC OS installation instructions
- ONIE overview
- Dell EMC DIAG OS
- Dell EMC DAIG-OS tools
- Dell EMC support
smartctl
smartctl controls the self-monitoring, analysis, and reporting technology (SMART) system built into most ATA/SATA and SCSI/SAS
hard drives and solid-state drives. The purpose of SMART is to monitor the reliability of the hard drive and predict drive failures, and to
carry out dierent types of drive self-tests.
smarttool
This optional tool is only available on systems using a SmartFusion chip. The SMF controls the PSU, LED control, fan monitoring, and
temperature control of the switch.
Use the smarttool to get and set the SmartFusion Active regions and version, and to reprogram the SmartFusion FPGA.
SmartFusion (SMF) had two upgradable parts — Microcontroller subsystem (MSS) and eld programmable gate array (FPGA), as shown.
The online upgrade MSS images are in *.bin les. The online upgrade of FPGA image is in a *.dat le. The external upgrade of both
MSS and FPGA is a *.pdb le.
There are three regions in the MSS: G — Golden, A — Primary, and B — Secondary. In principle, you cannot upgrade the region G and the
bootloader. Golden is the default bootable region. If both regions A and B become corrupt, the region G image is used for booting. If A
becomes corrupt, select region B and boot from region B.
Figure 5. smarttool upgradable MSS and FPGA
SMF upgrade binaries
• <platform>_SMF_MSS_v1.3.1_A_region.bin
• <platform>_SMF_MSS_v1.3.1_B_region.bin
• <platform>_SMF_MSS_v1.3.1_G_region.bin
• <platform>_SMF_Logic_v0.3.dat
CLI options
root@dell-diag-os:/opt/dellemc/diag/bin# smarttool
ERROR: main[100]: ERROR: Usage: smarttool <command> <UART dev> [<filename>|<REGION>]
-------------------------------------------------------
Usage:
smarttool <command> [<UART dev>] [<filename>|<REGION>]
Dell EMC DAIG-OS tools
71