Users Guide

VLT Unit ID Port-Channel Status Configured ports Active ports
---------------------------------------------------------------------
* 1 port-channel1 down 2 0
2 port-channel1 down 2 0
VLT ID : 2
VLT Unit ID Port-Channel Status Configured ports Active ports
---------------------------------------------------------------------
* 1 port-channel2 down 1 0
2 port-channel2 down 1 0
VLT ID : 3
VLT Unit ID Port-Channel Status Configured ports Active ports
---------------------------------------------------------------------
2 port-channel3 down 1 0
Supported
Releases
10.2.0E or later
vlt-domain
Creates a VLT domain.
Syntax
vlt-domain domain-id
Parameter domain-id — Enter a VLT domain ID on each peer, from 1 to 255.
Default None
Command Mode CONFIGURATION
Usage
Information
Configure the same VLT domain ID on each peer. If a VLT domain ID mismatch occurs on VLT peers, the
VLTi link between peers does not activate. The no version of this command disables VLT.
Example
OS10(config)# vlt-domain 1
Supported
Releases
10.2.0E or later
vlt-port-channel
Configures the ID used to map interfaces on VLT peers into a single VLT port-channel.
Syntax
vlt-port-channel vlt-port-channel-id
Parameters vlt-port-channel-id — Enter a VLT port-channel ID, from 1 to 128.
Default Not configured
Command Mode PORT-CHANNEL INTERFACE
Usage
Information
Assign the same VLT port-channel ID to interfaces on VLT peers to create a VLT port-channel. The no
version of this command removes the VLT port-channel ID configuration.
Example (peer 1)
OS10(conf-if-po-10)# vlt-port-channel 1
Example (peer 2)
OS10(conf-if-po-20)# vlt-port-channel 1
Supported
Releases
10.2.0E or later
1434 Virtual Link Trunking