Users Guide

Table Of Contents
telemetry
Enters Telemetry configuration mode to configure streaming telemetry.
Syntax
telemetry
Parameters None
Default Telemetry is disabled on the switch.
Command mode CONFIGURATION
Usage
information
Enable and disable streaming telemetry in Telemetry mode.
Example
OS10(config)# telemetry
OS10(conf-telemetry)#
Supported
releases
10.4.3.0 or later
enable
Enables telemetry on the switch.
Syntax
enable
Parameters None
Default Telemetry is disabled.
Command mode TELEMETRY
Usage
information
Enter the no enable command to disable telemetry.
Example
OS10(conf-telemetry)# enable
Supported
releases
10.4.3.0 or later
destination-group (telemetry)
Configures a destination group for streaming telemetry.
Syntax
destination-group group-name
Parameters group-name Enter the name of the destination group. A maximum of 32 characters maximum.
Default Not configured
Command mode TELEMETRY
Usage
information
A destination group defines the destination servers to which streaming telemetry data is sent. The no
version of this command removes the configured group.
Example
OS10(conf-telemetry)# destination-group dest1
OS10(conf-telemetry-dg-dest1)#
Supported
releases
10.4.3.0 or later
1504 Telemetry