Users Guide

ntp broadcast client
Configures all active interfaces to receive NTP broadcasts from an NTP server.
Syntax
ntp broadcast client
Parameters None
Default Not configured
Command Mode GLOBAL CONFIGURATION
Usage
Information
The no version of this command disables NTP broadcasts.
Example
OS10(config)# ntp broadcast client
Supported
Releases
10.2.0E or later
ntp disable
By default, NTP is enabled on all interfaces. Disable NTP to prevent an interface from receiving NTP packets.
Syntax
ntp disable
Parameters None
Default Enabled
Command Mode INTERFACE
Usage
Information
Use this command to configure OS10 to not listen to a particular server and prevent the interface from
receiving NTP packets. The no version of this command reenables NTP on an interface.
Example
OS10(conf-if-eth1/1/7)# ntp disable
Supported
Releases
10.2.0E or later
ntp enable vrf
Enables NTP for the management or nondefault VRF instance.
Syntax
ntp enable vrf {management | vrf-name}
Parameters
● management—Enter the keyword to enable NTP for the management VRF instance.
● vrf-name—Enter the keyword then the name of the VRF to enable NTP for that nondefault VRF
instance.
Defaults Disabled
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables NTP for the management VRF instance.
Example
OS10(config)# ntp enable vrf management
OS10(config)# ntp enable vrf vrf-blue
Supported
Releases
10.4.0E(R1) or later
162 System management