Users Guide

The no form of this command removes the configuration.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ptp transport ipv4 unicast master
Supported
Releases
10.5.1.0 or later
ptp vlan
Configures a VLAN for the PTP-enabled interface.
Syntax
ptp vlan vlan-id
Parameters vlan-id—Specifies VLAN for the PTP interface.
Defaults None
Command Mode INTERFACE CONFIGURATION
Security and
Access
Netadmin and sysadmin
Usage
Information
You can configure only one PTP VLAN per interface. If the PTP interface is in trunk mode, the VLAN tag
is added to PTP packets transmitted out of the PTP interface. The system accepts tagged ingress
packets, only if the configured PTP VLAN is present in the VLAN tag. The system accepts all untagged
packets. The no form of this command removes the configuration.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ptp vlan 10
Supported
Releases
10.5.1.0 or later
show ptp
Displays the PTP clock and port information.
Syntax
show ptp
Parameters None
Defaults None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
None
Example -
Boundary clock
OS10# show ptp
PTP Clock : Boundary
Clock Identity : 68:4f:64:ff:ff:01:db:ec
Grandmaster Clock Identity : 00:16:00:ff:fe:00:02:00
Clock Mode : One-step
Clock Quality
Class : 248
Accuracy : <=100ns
Offset Log Scaled Variance : 0
Domain : 0
Priority1 : 128
Priority2 : 128
Profile : System-default
194 System management