Users Guide

show ptp foreign-masters
Displays PTP information about foreign masters.
Syntax
show ptp foreign-masters [{ethernet node/slot/port[:subport]} | {port-
channel port-channel-id}]
Parameters
● ethernet node/slot/port—Enter the Ethernet interface information.
● port-channel port-channel-id—Enter the port channel interface number.
Defaults None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
The maximum number of foreign master data set entries is 10. This command is not applicable for
transparent clocks.
Example
OS10# show ptp foreign-masters
Interface : Ethernet1/1/22
-------------------------------------------------------------------------
Index Port-Identity Clock Clock Offset GM GM Announce Receiver
Class Accuracy Variance Pri1 Pri2 Msgs # Interface
-------------------------------------------------------------------------
0(Best)00:16::1 6 <=100ns 0 100 128 437 eth1/1/22
-------------------------------------------------------------------------
Supported
Releases
10.5.1.0 or later
show ptp interface
Displays PTP information about the interface.
Syntax
show ptp interface [{ethernet node/slot/port[:subport]} | {port-channel
port-channel-id}]
Parameters
● ethernet node/slot/port[:subport]—Enter the Ethernet interface information.
● port-channel port-channel-id—Enter the port channel interface number.
Defaults None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
For boundary clocks, this command indicates if the port is enabled or disabled. This command is not
applicable for transparent clocks.
Example
OS10# show ptp interface
Interface : Ethernet1/1/22
PTP : Enabled
Port Identity : 68:4f:64:ff:ff:01:db:ec:1
Port State : Slave
Vlan :
Transport : Ipv4-multicast
Log Delay Request Minimum interval : -4
Log Announce Interval : 1
Announce Receipt Timeout Multiplier : 3
Log Sync Interval : -4
Delay Mechanism : End-to-end
Interface : Ethernet1/1/23
PTP : Enabled
System management 197