Users Guide

Table Of Contents
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x host-mode multi-host
Supported
Releases
10.2.0E or later
dot1x max-req
Changes the maximum number of requests that the device sends to a supplicant before restarting 802.1X authentication.
Syntax
dot1x max-req retry-count
Parameters max-req retry-count Enter the retry count for the request sent to the supplicant before
restarting 802.1X reauthentication, from 1 to 10.
Default 2
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x max-req 4
Supported
Releases
10.2.0E or later
dot1x port-control
Controls the 802.1X authentication that is performed on the interface.
Syntax
dot1x port-control {force-authorized | force-unauthorized | auto}
Parameters
force-authorized Disables 802.1X authentication on the interface and allows all traffic on the
interface without authentication.
force-unauthorized Keeps the port in the unauthorized state, ignoring all attempts by the
client to authenticate.
auto Enables 802.1X authentication on the interface.
Default Force-authorized
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(config)# interface range ethernet 1/1/7-1/1/8
OS10(conf-range-eth1/1/7-1/1/8)# dot1x port-control auto
Supported
Releases
10.2.0E or later
dot1x reauthentication
Enables periodic reauthentication of 802.1X supplicants.
Syntax
dot1x re-authentication
Layer 2 441