Users Guide

lacp fallback timeout
Configures LACP fallback time-out period.
Syntax
lacp fallback timeout timer-value
Parameters timer-value—Enter the timer values in seconds, ranging from 0 to 100 seconds.
Default 15 seconds
Command Mode Port-channel INTERFACE
Usage
Information
The no version of this command returns the timer to default value.
Example
OS10# configure terminal
OS10(config)# interface port-channel 1
OS10(conf-if-po-1)# lacp fallback timeout 20
Supported
Releases
10.3.2E(R3) or later
lacp max-bundle
Configures the maximum number of active members that are allowed in a port channel.
Syntax
lacp max-bundle max-bundle-number
Parameters max-bundle-number — Enter the maximum bundle size (1 to 32).
Default 32
Command Mode INTERFACE
Usage
Information
The no version of this command resets the maximum bundle size to the default value.
Example
OS10(conf-if-po-10)# lacp max-bundle 10
Supported
Releases
10.2.0E or later
Lacp port-priority
Sets the priority for the physical interfaces for LACP.
Syntax
lacp port-priority priority
Parameters priority — Enter the priority for the physical interfaces (0 to 65535).
Default 32768
Command Mode INTERFACE
Usage
Information
LACP uses the port priority with the port number to create the port identifier. The port priority decides
which ports are put into Standby mode when there is a hardware limitation that prevents all compatible
ports from aggregating, or when you have up to 32 ports configured for the channel group. When setting
the priority, a higher number means a lower priority. The no version of this command returns the port
priority to the default value.
Example
OS10(conf-range-eth1/1/7-1/1/8)# lacp port-priority 32768
Supported
Releases
10.2.0E or later
Layer 2 465