Users Guide

Usage
Information
The no version of this command resets the value to the default.
Example
OS10(config)# lldp reinit 5
Supported
Releases
10.2.0E or later
lldp timer
Configures the rate in seconds at which LLDP packets send to the peers.
Syntax
lldp timer seconds
Parameters seconds — Enter the LLDP timer rate in seconds, from 5 to 254.
Default 30 seconds
Command Mode CONFIGURATION
Usage
Information
The no version of this command sets the LLDP timer back to its default value.
Example
OS10(config)# lldp timer 25
Supported
Releases
10.2.0E or later
lldp tlv-select basic-tlv
Enables or disables TLV attributes to transmit and receive LLDP packets.
Syntax
lldp tlv-select basic-tlv {port-description | system-name | system-
description | system-capabilities | management-address [ipv4 | ipv6]}
Parameters
● port-description — Enable or disable the port description TLV.
● system-name — Enable or disable the system TLV.
● system-description — Enable or disable the system description TLV.
● system-capabilities — Enable or disable the system capabilities TLV.
● management-address — Enable or disable the management address TLV (IPv4 and IPv6).
● management-address ipv4 - Enable or disable only the IPv4 management address TLV.
● management-address ipv6 - Enable or disable only the IPv6 management address TLV.
Default Enabled
Command Mode INTERFACE
Usage
Information
The no form of the command disables TLV attribute transmission and reception in LLDP packets.
Example
OS10(conf-if-eth1/1/3)# lldp tlv-select basic-tlv system-name
Supported
Releases
10.2.0E or later
lldp management-addr-tlv virtual-ip
Enables VLT peers to send the elected virtual IP address in the management address TLV.
Syntax
lldp management-addr-tlv {ipv4 | ipv6} virtual-ip
Layer 2 491